Paver sealing for Cedar Hills homes
Paver Sealing in Cedar Hills, FL
Cedar Hills has about 3,000 brick and block ranch homes, so call (912) 600-8118 to ask what your pavers need.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Fast, careful paver sealing in Cedar Hills
Paver sealing is available across Cedar Hills, from the blocks near Blanding Boulevard to the streets that run down toward the Cedar River. The contractor cleans, re-sands and seals driveways, patios and walkways, and the estimate is free. A call to (912) 600-8118 gets a reply within 1 business day, often much sooner.
Maybe your driveway is long and gray, and the joints have more weeds than sand. Maybe the patio outside the sliding door has gone blotchy. A wash, new sand and a coat of sealer bring each one back to a single clean color, and you can ask for a free estimate to find out what yours would take. No obligation comes with the estimate.
Why hire a local paver sealing contractor in Cedar Hills?
Mid-century homes, long drives and hard-working storm drains make Cedar Hills a place for local paver knowledge. Ask how that applies to your street when you ask for a free estimate.
A free look at the drive
A local contractor measures your Cedar Hills driveway and patio at no charge, then gives you a price. You decide afterward, and nothing is owed.
A range for comparison
Bids across Northeast Florida can be checked against the published $1.75 to $3.25 per square foot.
Finish chosen by you
Matte or wet look is your call. Wet look shows scuffs sooner, which counts on a long drive where cars turn and park.
No pressure to book
An estimate carries no obligation. You pick the date, and the contractor works around your schedule and the weather.
Get Your Free Estimate in Cedar Hills
Tell us about your pavers in Cedar Hills.
Free, no obligation
What paver problems show up most in Cedar Hills?
Storm drains that back up
A Cedar Hills homeowner of more than 40 years told News4JAX in 2017 that a blocked storm drain was flooding her yard and making the ground cave in. The city said it would clear the debris and fix the headwall. Water that runs across a lot in a new pattern carries sand and silt with it. Pavers that took that water need a wash before any sealer goes down. Ask the contractor to look at the corner of the drive nearest the street drain, since that is where a pattern like that shows up first. Fixing the cause of the water is a job for you or the city, and sealing does not replace it.
Wide fronts and long drives in the sun
Lot frontages in Cedar Hills are typically large, with wide setbacks, so a driveway can run a long way from street to garage. A Jacksonville company says open driveways take more sun and need resealing sooner than shaded walks. A builder adds that Jacksonville sun fades unsealed concrete pavers within three to five years. Fade shows first where the sun sits all afternoon. Cars parked in the same spot every day add oil and tire marks to the same few feet of paving. Those spots get pre-treatment during the wash, and sealing afterward makes new spills easier to rinse off before they soak in.
Pavers added to 1950s block homes
Homes in the area were built in the 1940s and 1950s, and in nearby Cedar Hills Estates between 1955 and 1971. Pavers came later, laid by owner after owner. That leaves an unknown coat on many drives. A water-based product cannot be laid over a solvent-based one, so the contractor finds out what is down first. If you have lived in your house a long time, you may remember who laid the pavers or which year they went in. That memory helps, and a photo of the original work helps even more when the contractor plans the job.
Roof water along the patio edge
Ranch homes often have large overhanging eaves and a patio outside a sliding glass door. Roof water drips in a line along that edge, which can leave a dark strip in the joints. Shade from the eave keeps that strip damp. The strip is cleaned first, then sanded and sealed with the rest of the patio. Brick or block walls beside the patio are rinsed gently so the spray does not push water into the wall. The contractor also checks the patio edge for loose pavers before any sand goes in.
Joint sand that goes with the rain
Rain is heavy in Jacksonville from May to September, and one builder says the downpours flush sand out of unsealed joints. Weeds root in the gaps, and the pavers can wander. A driveway with cars turning on it loses sand even faster. Fresh sand and a coat of sealer hold the joints in place through the next summer. Sealer locks the sand in once it cures, which means the first few big storms after a job are when the new coat earns its keep. Weeds that were rooting in open joints lose their foothold.
Is every one of the seven Cedar Hills neighborhoods covered?
Yes, each one can. Cedar Hills runs from Blanding Boulevard on the east to Lane Avenue on the west, with about 3,000 brick or block homes in seven neighborhoods. Streets in Cedar Hills carry nursery-rhyme names such as Mother Goose Road and Peter Pan Place. Tell the contractor which stretch you live on when you ask for a free estimate.
Along the Cedar River, many homes have been greatly expanded or replaced with much larger ones. A rebuilt riverside house may have new pavers, while a street inland has pavers from several owners back. Those are two different jobs. Call (912) 600-8118 and say which one you have.
If your Cedar Hills street has no association, the finish is your choice, though you should check your own deed. Matte or wet look, either way, the contractor can explain how each wears. When you are set, ask for a free estimate and ask for samples of both.
What does paver sealing cost in Cedar Hills?
Expect a price somewhere from $1.75 to $3.25 per square foot, the span companies across Northeast Florida publish for cleaning, sanding and sealing. A Cedar Hills job moves within that range with the length of the drive, the sand left in the joints and any old coat. A patio and a walkway are priced with the driveway by total area. For a figure tied to your driveway, ask for a free estimate, and nothing is owed for the estimate.
A long, open driveway has plenty of square feet, so the total can climb even at a low rate. A small, shaded patio may cost less overall but need a longer wash. Rust or oil stains add time. Call (912) 600-8118 and ask which of these your drive would run into.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $525 to $975 |
| 600 sq ft | Two car driveway | $1,050 to $1,950 |
| 1,000 sq ft | Large driveway or pool deck | $1,750 to $3,250 |
| 1,500 sq ft | Driveway plus pool deck | $2,625 to $4,875 |
Math based on the $1.75 to $3.25 per square foot that Northeast Florida paver companies publish. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.
How does a paver sealing job work in Cedar Hills?
Walk the drive and note the low spots
The contractor walks your Cedar Hills driveway from street to garage and checks where water runs. Pavers that have sunk get repaired ahead of the coat, since sealing would preserve the dip. The type of any old coat is noted, because a solvent-based one rules out a water-based topcoat. Share what you know about earlier owners. Taking photos of the drive, the patio and any stain gives the estimate a record to work from. You then see the plan and the price in writing.
Wash the whole surface
The wash lifts oil, tire marks, green film and any dark line from roof drip. Orange rust marks from sprinklers get their own treatment. Spray is held back from the brick or block wall along the foundation. Cleaning near the garage door gets extra attention, because that is where oil and tire marks collect most. Dark lines under the eaves get a second pass.
Re-sand every joint
Washing pulls out the joint sand, so fresh sand goes in before sealing. On a long drive that is a lot of joints, and each one needs to be full. The surface is then swept so nothing loose sits on top. Sand that has settled into the joints is brushed in more than once, since fine sand moves into the gaps slowly. The last sweep takes up whatever has not gone in.
Let the pavers dry
Sealer needs a dry surface, and a wet look can turn cloudy white if it goes on damp pavers. A sunny Cedar Hills drive dries fast, while a patio under an eave takes longer. The contractor waits for a dry window instead of coating moisture. On a hot day a driveway can dry in an hour or two, but cool or humid weather slows it. Dew on the pavers also counts as moisture, so mornings may be a late start.
Seal and stay off
Sealer goes down in even coats across the whole drive. Plan on a few hours before people walk on it and roughly a day before a car does. Plan to park on the street or in the garage for the night so tires do not mark the new coat. You will be told how long the sealer needs, so you know when guests can walk across it and when cars can pull in.
Complete paver services in Cedar Hills
Here is how a Cedar Hills job goes. The contractor looks, washes, puts sand back in the joints, waits for the pavers to dry and then seals. A patio is quick, and a long driveway takes more of the day. Call (912) 600-8118 to ask about yours.
Driveways take oil, tires and long hours of sun. Patios by the sliding doors get feet, chairs and grills, and any pool deck gets splash. Front walks get rain and leaf fall. Say which ones you have when you ask for a free estimate.
A water-based coat will not go over a solvent-based one, so the old product comes first. After that, you choose how it looks. Matte stays quiet on a ranch front, and a wet look deepens color at the price of earlier scuffs. Call (912) 600-8118 to talk about which suits your drive.
Summer storms in Jacksonville are brief but intense, so give a Cedar Hills job some extra days in the schedule. A long drive in full sun dries fast, but a shaded patio does not. Cool, humid mornings slow drying too. To lock in a day, ask for a free estimate and say how long your drive is.
Questions to ask before you hire
- Will you cover my plants and shield the siding and the screen enclosure?
- Does the quote cover pressure washing, new joint sand and the sealer, or are those priced apart?
- What happens if it rains soon after the sealer is down?
- How often should sealed pavers be sealed again in this climate?
- How long until we can drive on the driveway and set the patio chairs back?
- Can you send proof of insurance before the work day?
- Is there a gloss level that keeps the pool deck from getting slick?
What do sealed pavers look like around Cedar Hills?
Why local matters in Cedar Hills
A contractor who works Cedar Hills knows these streets were built for cars and wide yards. A long drive is a lot of pavers, and a good plan breaks it into sections. Someone new to the area may not think of that. Call (912) 600-8118 to reach a contractor who works Westside streets.
Local knowledge also covers the ground. The 2017 storm drain story shows that runoff can reach yards and pull dirt along with it. A contractor from the area asks where water goes on your lot. You can ask for a free estimate and describe what happens after a storm.
Many homes here are mid-century, with owners who have changed pavers and sealers over the years. A local contractor expects to find coats nobody remembers. That is why the old product gets checked before anything else. If you know who sealed your pavers, mention it when you call (912) 600-8118.
What is Cedar Hills known for besides its ranch homes?
It is known for streets named from nursery rhymes, including Mother Goose Road, Peter Pan Place and Flopsy, Mopsy and Cotton Tail lanes. The Cedar Hills Shopping Center was completed in 1955 and once held a JCPenney and a movie theater. If you live near the center and your walk looks tired, ask for a free estimate. Blanding Boulevard and Lane Avenue frame the neighborhood on either side.
The Cedar River wanders through the Westside before joining the Ortega River, and weekend anglers like it. Blanding Boulevard and 103rd Street carry the shops, and the Mary Lena Gibbs Community Center sits in the nearby Sweetwater area. If your street is near one of these spots, call (912) 600-8118 and say which. That center stands where a National Guard armory was built in 1957.
Frequently Asked Questions
Does sealing pavers in Cedar Hills, Florida, pay off?
Usually, yes. A long driveway in the Cedar Hills sun is exactly where a sealer earns its keep, since a Jacksonville builder says sun fades unsealed concrete pavers within three to five years. Sealing also helps keep sand in the joints and mildew off.
How long do paver sealers last in Cedar Hills?
Think two to five years per coat, which is what companies quote. A wide, open driveway in full sun sits near the short end. If sprinkled water soaks in instead of beading, the coat is worn. A water test on a dry day, with a little sprinkled on the surface, gives a quick answer.
How much does it cost to have pavers cleaned and sealed in Cedar Hills?
The commonly published range in Northeast Florida is $1.75 to $3.25 per square foot to clean, sand and seal. A long driveway raises the total even at a low rate. Compare quotes by area as well as by total.
Why is paver sealing so expensive in Cedar Hills?
Most of the bill is the work around the sealer, as one Jacksonville builder describes it: prep, drying and an even coat on top of fresh joint sand. A long Cedar Hills drive adds area, which adds hours. The range you see is a whole-job figure.
Is there a pressure washing business that seals pavers in Cedar Hills?
Yes, local exterior companies across Jacksonville wash, re-sand and seal pavers. Washing is the first step of any sealing job, because sealer would lock in dirt. The contractor you reach after you ask for an estimate can explain how the wash is done. Ask for the steps in writing, so you know the wash, re-sand and seal are all included.
Does a Cedar Hills homeowner need HOA approval to seal pavers?
Many Cedar Hills homes do not have an HOA. If you do belong to one, ask what applies before the date is set. Check your deed or ask neighbors if you are unsure, and keep the answer for the contractor.
Can a blocked storm drain damage my pavers?
It can. A 2017 News4JAX story described a Cedar Hills drain that flooded a yard and left the ground caving in. Pavers that sit in moving water can lose sand and settle, and any sunken spot is repaired before sealing. Repair of the ground comes first if a drain is failing, since sealing only protects the surface.
What if my driveway has oil or rust stains?
They are treated before sealing, and many lighten a lot. A Jacksonville paver company says deep stains may not come out completely, and sealing locks in whatever is there. Ask the contractor what to expect before the day. New spills are easier to wipe up once the surface is sealed. Rust usually comes from irrigation water high in iron, according to a University of Florida source.
Nearby areas we serve
Ready for a Free Estimate in Cedar Hills?
Call (912) 600-8118 and tell us about your pavers.
Free, no obligation